Moisture or Steam separator use for
separating water droplets from steam. It is important to remove water droplets
from steam because it effects on the productivity and quality of the product
also it can damage the engine in many ways by reducing the thermal efficiency
or corrosion, water hammer, hydraulic lock in the engine. Equipment are very
costly nowadays like flow meters, control valves etc. and due to wet steam they
can be easily damage. Because water droplets travels at high
steam velocities so it erode the valve seats and fittings, and this condition
is known as wire drawing. Also water droplets will increase the amount of
corrosion. It also Increase the scaling of pipe work and heating surfaces from
the impurities available in the water droplets.
In result Failure of valve seats. To
avoid this kind of issue we used moisture separator or steam separator.
·
No electricity
·
Mount inline
·
Centrifugal action for
particle separation
·
Long lasting cartridges
There are three types of separator in
common use in steam systems:
Baffle type
Baffle or vane
is type of moisture separator in which there are number of baffle plates. When
wet steam will pass from separator body it will separate the water droplet from
the steam, the dry steam flows around the baffles and the water droplets
collect on the baffles. The condensate collects in the bottom of the separator,
where it will drain away through a steam trap.
Cyclonic Type
Cyclonic or
centrifugal is type of moisture separator in which series is used to generate
high-speed cyclonic flow. The wet steam swirl around the separator’s body and
throw the heavier suspended water to the wall.
Coalescence Type
Coalescence is type of moisture separator which block (wire mesh pad) the steam path
to absorb the water molecules. As
the size of the droplets increases, the obstruction become too heavy and falls
into the bottom of the separator.
Insulation
If a separator
is not uninsulated, it can raise water droplets to form rather than removing them,
because of the large surface area exposed to the environment, and great amounts
of heat energy can be lost from the surface of the separator.
With the help of an insulation jacket,
this heat loss can be much reduced and the energy savings justify the initial
cost of the insulation, within very short time. An Insulation jackets is designed to fit over a
particular separator.
Annair Drychill Tech (I) Pvt, Ltd Mumbai Manufacture Company Unit No. 101, I Wing, Plot - K1, Udyog Bhavan-2, Additional M.I.D.C, Anandnagar, Ambernath East, Thane- 421506, Maharashtra, India. Undoubtedly it is one of the best Manufacturer Company in Mumbai.
Mail US: sales@annair.com
Call US: 9320950116/ + (91)-251 2620660
No comments:
Post a Comment